Power plant desulfurization process abrasion-resistant pump
There are two series of desulfrization process slurry pump DT and
TL.
The material of wet parts are mainly Cr30 and A49, high
abrasion-resistant and hig corrosion resistant. For TL series,
there is also rubber material for wet parts.
DT and TL pumps are mainly used for transfering slurry in power
plant FDG process.
T,TL Series Desulfurization Pump
Model: 550DT-750
Material: High chromium alloy
Usage: used as large circulating pump of absorption tower,
limestone slurry delivery pump, gypsum discharge pump, recovery
pump, pit pump, etc.
Layout: Horizontal
Transmission type: DC Direct drive, Cr parallel belt drive, zvz
upper and lower belt drive, CV vertical belt drive, etc.
Flow: 1664-5600m 3/ h
Lift: 5.2-27.8m
Speed: 300-595r / min
DT and TL FGD special pumps are a generation of high-efficiency
series FGD pumps carefully developed by our company based on the
successful design and manufacturing experience of ZJ series slurry
pumps, according to the characteristics of domestic FGD pumps and
absorbing the advanced technology of similar products at home and
abroad. The large flow range of the pump can reach 12000m 3/ h. The
pump head is generally less than 100m, covering all pump working
conditions of desulfurization system. It can be used as large
circulating pump of absorption tower, limestone slurry transfer
pump, gypsum discharge pump, recovery pump, sump pump, etc.
Structural style: DT type adopts horizontal, single shell pump,
single-stage single suction, off frame or suspension structure.LT
type adopts single shell vertical structure, and suction pipe can
be added to meet the requirements of various working conditions.
Flexible coupling Applicable working conditions PH value of slurry:
2.5-13 Chloride ion concentration: ≤ 60000ppm Weight concentration:
≤ 60% Medium temperature: ≤ 120 ℃ Shaft seal form All shaft seals
adopt mechanical seals, including water type and anhydrous type.
